Neopost AS-Orbit Base R2L, Mounting Instruction, Page: 6 / 12

6
18 Reassemble the complete head support with the 8
screws. Before you tight the screws make sure that the
support is on the same level as the conveyor.
The figure shows only two screws.
19 Remove the long ground cable from the original position
and connect it again on the market position and inside
on a free grounding point.
20 Reassemble both emergency plates on the front and on
the back side. Figure shows the front side.
21 A blind cover on the emergency plate may not fit.
Check point 16; the hose clip must not touch the frame.
22 Cut the blind cover on one side.
23 Assemble the aluminium profile for the light sensor bar.
With the countersunk screw fix the plate on the profile.
You will need the “Conversion kit AS-Orbit Base R2L”
P/N: 9203514T