6
Before installing the memory card switch the device off
ATTENTION:
Make sure that the memory card‘s position
is right. Your attempt to insert the memory card facing
the wrong direction may bring about damage
to the device and also to the memory card
Warning:
НDo not apply too much force when installing
the memory card to avoid damage to the device.
In order to install the memory card insert Micro SD card into the slot pushing it
down all the way (till it clicks); if needed, use an installation needle. In order to
remove the card, press it until it clicks and pull it out of the slot.
USB connector:
USB connector is meant for charging, and connecting to computer. In order to
transfer data from your device to computer, use cable from the supplied kit,
switch off the device by pressing POWER button, and make sure that the device
is switched off. Insert into your device mini-USB –B connector, and into the com-
puter – USB type A connector.
For the purpose of securing feeding (car battery charging) connect your video
recorder to the car power supply network through the charger included in the kit.
[ Special functions ]
G sensor
This function allows adjusting the sensitivity level of G sensor initiating automated
protection of current video in case of violent speeding, braking, knocking, turning,
or tossing on an uneven road, etc. Upon G sensor’s activation, the current file is
blocked from re-recording. This secures the safety of files even if the memory card
has been re-recorded several times during the loop recording.
Auto switch off
Upon switching on this function, video recorder will switch off automatically after
a previously set interval of time following the car engine’s shut off.
