•
Check the instrument and accessories before hand for damage each time you use them. Do not use
damaged components. Accessories must be securely attached to the device and cannot come off by
themselves. Always disconnect the plug before fitting accessories.
The instrument can only be disconnected from the main power supply by pulling out the mains plug or the
connector plug.
•
The voltage stated on the label must correspond to the main power supply.
•
The instrument may only be opened by experts.
•
Keep away from high magnetic held.
•
Observe the minimum distances between the devices, between the device and the wall and above the
assembly (min. 100 mm).
Proper use:
The instrument is designed for mixing liquids in schools, laboratories or factories. This device is not suitable for
using in residential areas or other constraints mentioned in Chapter 1.
Inspection:
Unpack the equipment carefully and check for any damages which may have arisen during transport. If it
happens, please contact neolab for technical support.
Trial run:
•
Make sure the required operating voltage and power supply voltage match.
•
Ensure the socket must be earthed reliably.
•
Ensure the power be off
•
Plug in the power cable
•
Ensure the two-direction switch must be in the middle ( off state ) before powering on
If these operations above are normal, the device is ready to operate. If these operations are not normal, the
device may be damaged during transportation, please contact neolab for technical support.
neoLab Migge Laborbedarf-Vertriebs GmbH, Rischerstr. 7-9, 69123 Heidelberg
Tel. 06221 / 84 42-0 [email protected] www.neolab.de
neoLab Berlin Tel. 030 / 30 87 45-0 neoLab München Tel. 089 / 35 61 88 -0
