Quick Start Guide ePowerSwitch 8 M/S (M8 / S8) V.11/2006 Page
16
DEVICE PARAMETERS SETTINGS
Command /DP
With the commands in this menu, you can:
specify an e-mail address for problem reports: if a slave device without power is accessed by
a user, the mail client will pop up with that address in the To field. The user can then send
this message manually to the administrator.
activate and deactivate an ePowerSwitch slave connected to an ePowerSwitch master.
define the control mode (Single or Twin) for each ePowerSwitch device.
In
Single mode
, you can control each power socket individually.
In
Twin mode
, you can control two power sockets with one command. This mode is intended
mainly for restarting devices with redundant power supplies. Here, the four sockets fed by
power supply A (sockets 1 to 4) are automatically linked with the four sockets fed by power
supply B (sockets 5 to 8).
DEVICE PARAMETERS SETTINGS
1. Mail to
2. Device #1 Activated Twin Mode
3. Device #2 Activated Twin Mode
4. Device #3 Not Activated Single Mode
5. Device #4 Not Activated Single Mode
6. Device #5 Not Activated Single Mode
Enter Selection or <ESC> to exit
>
Command 1
MAIL TO SETTING
Mail to is:
Enter Name (max. 32 characters) or <ESC> to exit
>
DEVICE 1 PARAMETERS SETTINGS
Device #1 Activated Twin Mode
1. Single Mode / Twin Mode
2. Activate / Deactivate
Enter Selection or <ESC> to exit
>
Command 1
DEVICE 1 PARAMETERS SETTINGS
Mode is: Twin Mode
1. Twin Mode
2. Single Mode
Enter Selection or <ESC> to exit
>
DEVICE 1 PARAMETERS SETTINGS
Device is: Activated
1. Activate
2. Deactivate
Enter Selection or <ESC> to exit
>