29
Type of Action
For the Event defined above, you can choose and configure following actions:
Set Outputs
This type of Action can only be configured if:
- your Device has own Power Outlets or has access to Power Outlets of connected xBus Peripheral
Units
- your Device has own Relay Outputs or has access to Relay Outputs of connected xBus Peripheral
Units
- your Device has access to Relay Outputs of connected xBus Peripheral Units
- you have created interface associations (Go to Settings/Associations).
Select this checkbox and choose in the corresponding drop-down lists the Output to use for this Rule.
Each Power Outlet can be switch to On, Off or Restarted.
If you choose "Restart" you can also define a Restart delay between 0 and 3600 seconds.
- If you choose 0 second for the delay, the delay will be the delay defined in the "Power Outlets Page".
- If you choose a delay different from 0, this delay will replace the delay defined in the
"Settings/Peripherals/Edit Page".
Each Relay Output can be switch to Open, Close, Pulse Open, Pulse Close.
If you choose Pulse open or Pulse close you can also define a delay between 0 and 3600 seconds.
- If you choose 0 second for the delay, the delay will be the delay defined in the "Power Outlets Page".
- If you choose a delay different from 0, this delay will replace the delay defined in the
"Settings/Peripherals/Edit Page".
LOGOUT:
Click "Logout" at the bottom of the page to exit the session without saving changes.
DISCARD CHANGES:
Click "Discard Changes" at the bottom of the page to discard all the changes you have made on this page.
APPLY CHANGES:
Click "Apply Changes" at the bottom of the page to save changes.
