Neodrives Smart MMI, User Manual

Page: 6 / 22

8 5
3.1 Fitting and removing the sMMI
Fitting
Place the sMMI [4] in the correct position (the “neodrives” logo faces the rider) and
skewed at an angle of about 30 degrees to the dock [5] (see diagram).
Turn the sMMI [4] on the dock [5] using slight pressure by 30 degrees clockwise so that
both components are in alignment. The electrical connections to the controller, motor
and battery pack are thereby automatically established.
Removing
Turn the sMMI [4] on its dock [5] by about 30 degrees anticlockwise. The electrical
connections are thereby disengaged and the sMMI [4] can be removed. Before removing,
the sMMI needs to be switched off (see section 3.2).
To protect your Pedelec from unwanted use by a third party or against theft,
the sMMI should always be removed from the handlebar when not in use.
Removing the sMMI, though, does not replace securing your Pedelec against
theft by other suitable means (using a bicycle lock, a safety chain or similar
device).
3.2 Functions of the sMMI
3.2.1 Switching on and off
Switching on
To switch on the sMMI, tap the menu button [2] on the controller. After a few seconds a
welcome screen appears, followed by the start menu, which is shown to the side.
If functions are already activated or the battery is not fully charged, the display of your
sMMI may differ from the illustration in some parts.
Switching off
To switch off your Pedelec you need to press down button [2] on the controller for about
2 seconds when the start menu is displayed. This takes you to the sub menu depicted
to the side, in which display you can jump up or down using buttons [1] and [3] of the
controller. The selected field in each case is displayed within a U-shaped border.
Select the field “Switch off” and tap button [2]. Your Pedelec is now switched off.
Automatic switch-off
If your Pedelec is not used for 10 minutes, the system is automatically switched off.
Pressing the menu button again switches the system on once more.
Do not switch your Pedelec off by removing the sMMI, the electronics
could be damaged by this.
i
Back
Switch off
Menu
!