Neodrives Smart MMI, User Manual, Page: 14 / 22

8 13
Warning – system fault
Inside the warning symbol, instead of the exclamation mark, various letters are shown (for instance the letter
“B” in the accompanying diagram), which mean the following:
B = battery fault
C = communication fault in the system
M = motor fault
R = controller fault
When a fault occurs, motorised support is not available.
Please contact your specialist dealer.
3.2.12 Easy Display mode
By activating Easy Display, the following graphical symbols presented in section 3.2.2 are enlarged on the display.
•
indication of the current speed travelled
•
indication of the daily kilometres travelled (requires prior reset, see section 3.2.10)
•
indication of the remaining battery capacity including indication of the expected remaining range
The relevant display can be selected by tapping button [2] on the controller.
If buttons [1] or [3] are tapped, the display shows the assistance level for about 3 seconds that can be increased or decreased using the
two buttons.
Activating Easy Display
From the start menu you go via
Menu – Settings – Easy Display to display “on/off”.
If Easy Display is activated, the sMMI automatically goes into this mode every time it is switched on.
Deactivating Easy Display
To deactivate the mode you need to press button [2] on the controller for about 2 seconds. Via
Menu – Settings – Easy Display you arrive
at the display “on/off”.
When Easy Display is activated the functions “pushing aid” and “recuperation” are not available.
3.2.13 Other settings
As standard, your sMMI has a German user interface. However, if required, an English / Dutch / French interface can be activated.
The software status of the sMMI, the motor and the battery pack can also be retrieved from the menu item “information”.
Language activation or status requests are performed similarly to the procedures described in the previous sections via various menus and
sub menus.
3.2.14 USB port
The sMMI has a USB port [14], which is primarily used by your specialist dealer to carry out maintenance and
diagnosis work. Ensure that the rubber cover is always fully inserted and seals the port. If the sMMI is not
fully sealed, moisture can get inside or fog the display from the inside.
In addition to English we can also set Dutch and French. However, if required, an English / Dutch / French interface can be activated.
i