What is Z-Wave?
Z-Wave is the international wireless protocol for communication in the Smart Home. This device is
suited for use in the region mentioned in the Quickstart section.
Z-Wave ensures a reliable communication by
reconfirming every message (
two-way
communication
) and every mains powered node
can act as a repeater for other nodes (
meshed
network
) in case the receiver is not in direct
wireless range of the transmitter.
This device and every other certified Z-Wave
device can be
used together with any other
certified Z-Wave device regardless of brand
and origin
as long as both are suited for the same
frequency range.
If a device supports
secure communication
it will communicate with other devices secure as long as
this device provides the same or a higher level of security. Otherwise it will automatically turn into a
lower level of security to maintain backward compatibility.
For more information about Z-Wave technology, devices, white papers etc. please refer to
Product Description
This product can be included and operated in any Z-Wave network with other Z-Wave certified devices
from other manufacturers and/or other applications. All non-battery operated nodes within the network
will act as repeaters regardless of vendor to increase reliability of the network.
In the front casing, there is button that is used to carry out include, exclude or reset factory default
settings on PCB Board.
When power is first supplied, the LED will flash on and off alternately at one second intervals within 5
seconds if the detector has not been added a Z-Wave network. Please get familiar with the terms
below before starting the operations.
Prepare for Installation / Reset
Please read the user manual before installing the product.
In order to include (add) a Z-Wave device to a network it
must be in factory default state.
Please
make sure to reset the device into factory default. You can do this by performing an Exclusion
operation as described below in the manual. Every Z-Wave controller is able to perform this operation
however it is recommended to use the primary controller of the previous network to make sure the
very device is excluded properly from this network.
Reset to factory default
This device also allows to be reset without any involvement of a Z-Wave controller. This procedure
should only be used when the primary controller is inoperable.
1.Remove the device cover
2.Make sure the sensor is powered
3.Press and hold the button for 10 seconds
4.Release the button.