15301
-
ML002 REV01 ECN 5789
Page 6
Caution Notices
CAUTION: Servicing of this product or unit is to be performed by trained service personnel only.
CAUTION: Energy hazard present. Shorting might result in system outage and possible physical injury. Remove any
jewellery before servicing.
CAUTION: For safety when running the printer test, make sure hair is pulled back and personal articles such as
ties, necklaces, or bracelets do not get caught in the moving print head.
CAUTION: Hazardous moving parts nearby.
CAUTION: Turn off or remove the fan
’
s connection to power before attempting to service the fan. Ensure the fan
has stopped moving before servicing.
CAUTION: The socket
-
outlet must be installed near the equipment and must be easily accessible.
CAUTION: This product is equipped with a 3
-
wire (two conductors and ground) power cable and plug. Use this
power cable with a properly grounded electrical outlet to avoid electrical shock.
Electronic Emission & Safety Notices
Neo Products cannot accept responsibility for any failure to satisfy the protection requirements resulting from a non
-
recommended modification of the product.
Properly shielded and grounded cables and connectors must be used in order to meet emission limits. Neo Products is
not responsible for any radio or television interference caused by using other than recommended cables and
connectors or by unauthorized changes or modifications to this equipment.
Unauthorized changes or modifications could void the user
’
s authority to operate the equipment.
Cable Ferrite Requirement
All cable ferrites are required to suppress radiated EMI emissions and must not be removed
.
Electrostatic Discharge (ESD)
Attention: ESD damage can occur when there is a difference in charge between the part, the product, and the service
person. No damage will occur if the service person and the part being installed are at the same charge level.
ESD Damage Prevention
Anytime a service action involves physical contact with logic cards, printed circuit boards (PCBs), modules, back
-
panel
pins, or other ESD sensitive (ESDS) parts, the service person must be connected to an ESD common ground point on the
product through the ESD wrist strap and cord. The ESD ground clip can be attached to any frame ground, ground braid,
green wire ground, or the round ground prong on the AC power plug. Coax or connector outside shells can also be used.
Handling Removed Cards
Logic cards removed from a product should be placed in ESD protective containers. No other object should be allowed
inside the ESD container with the logic card. Attach tags or reports that must accompany the card to the outside of the
container.
