neo-tools.com
8
Battery replacement
•
Carefully pull the lid latch in order to unlock the battery lid (
5
).
•
Insert 3 new AA batteries, observe correct polarity indicated on the battery lid with +/- symbols.
•
Close the battery lid, make sure the latch snaps in place.
"Pulse" feature changes laser beam frequency, using it is recommended in sunlight. Depending on ambient
conditions (light intensity, colour and roughness of the surface the laser is projected to), this feature on or off may
improve laser visibility.
HOW TO OPERATE THE STAND
•
Drive threaded pin into stand thread in the laser base to attach the level laser to the fixing plate (
8
).
•
Adjust length of the stand legs with latches (1 and 2).
•
Install the laser in the stand. To do so, pull the lever (
6
) and place the fixing plate (
8
) in the stand holder. Let go
the lever (
6
) and make sure the laser is securely fixed.
•
Loosen the knob (
4
) to set the laser to the right or left.
•
Loosen the knob/handle (
5
) allows to set the laser up or down.
•
Loosen the knob (
7
) to set the laser at an angle.
•
Crank (
9
) allows to set the stand height with precision. Once desired height has been set, tighten the knob (
3
)
to lock the height.
HOW TO OPERATE THE LASER – SELF LEVELLING FEATURE
The laser offers self-levelling feature. The feature is operational within ±4° of the laser tilt.
•
Switch the laser on, slide the self-levelling lock switch (
1
) to unlocked position.
•
When the laser angle does not allow the self levelling feature to work (greater than 4°), the laser will signal the
problem by intermittent sound, laser flashing and battery level indicator diode flashing.
•
Set up the laser so it does not signal incorrect position, only then it will be possible to set vertical and horizontal
line.
•
Press the feature toggle button (
2
) to toggle between showing horizontal line, vertical line and both.
•
Line visibility can be improved with the "Pulse" feature. To switch this feature on, press the button (
3
).
•
To switch the laser off, slide the self-levelling lock switch (
1
) to locked position.
The stand is equipped with a level (
10
). It makes work easier when you set the stand holder horizontally
before attaching the laser and switching it on.
HOW TO OPERATE THE LASER – LASER LOCK FEATURE
The laser lock feature allows to project straight lines at any chosen angle.
•
Leave the lock switch (
1
) in locked position.
•
Press the Pulse button (
3
) to switch the laser on.
•
Press the Pulse button (
3
) again to toggle between showing horizontal line, vertical line, both lines and
switching the device off.
Summary of Contents for 75-102
Page 2: ...neo tools com 2 1 2 3 5 4 9 1 6 2 8 7 3 4 5 8 10 6 5 7 8 ...
Page 35: ...neo tools com 35 ...
Page 36: ......
