NEO TOOLS 08-823, Instruction Manual

Page: 7 / 20

neo-tools.com neo-tools.com
7
EXAMPLES OF SETTING
5.85 N.m
52 Lb.in
22.
25.0 N.m
221 Lb.in
0.9
230
25.5
0
27
210
24
N m
1.1 1.0
331 N.m
244 Lb.ft
113.5 N.m
84 Lb.ft
30
230
10
250
335
S
T
O
P
320
12 11
30 N.m
wrench
Lb
m
N
70 50
1.4
7.5
N
1.3
4.5
6
1
335 N.m
wrench
90 70
125
4
N m
3
95
0 110
100 Lb.ft
wrench
59 Lb.ft
80 N.m
23.5 Lb.ft
32 N.m
55
Lb.ft
20
65
Lb.ft
60
4
3.5
90 80
40
30
30
25
3
50
70
Lb
N
USE OF EXTENSIONS
Attachments and non-standard heads will cause the applied torque to be different from the set torque.Consequently when
using them,the set torque must be adjustd in accordance with the formula shown on below.
A
3
30
0.
5
40
45
0
N
m
35
E L
T(E) - Torque applied by extension (de sired torque)
T(W) - Torque set on the wrench
T(W) = T(E)
L
L+E
APPLYING TORQUE
1. Insert an appropriate socket or drive attachment onto the square drive of the ratchet and onto the fastener you want to
tighten.
2. Apply hand pressure to the grip, and ONLY TO THE GRIP. You may support the wrench at the ratchet head with the other
hand to steady it, especially when using long socket extensions, with out appreciably affecting the accuracy of the wrench.
3. If, due to the required effort, you need to use both hands, put the other hand on the top of the first hand, never on any
other part of the wrench.
4. Apply slow and steady pull or push until the wrench momen tarily releases, with or without a distinct "click" sound. Release
the pressure right at this point. DO NOT OVERTORQUE!
SAFETY WARNING
Overtorqued or defective fasteners, sockets, as well as the wrench itself, may suddenly break causing you to lose balance, fall, or
to suffer other trauma. Be sure that you have firm footing, are properly balanced, and if necessary are using appropriate harness,
back support, or other safety device.
MAINTANANCE
1. When not in use, adjust the wrench to its lowest reading and store it in the provided case.
2. With the exception of the ratchet mechanism, do not lubricate the wrench. The ratchet mechanism may be lubricated as
needed with a few drops of light machine oil.