Neo Instruments VENTILATOR II, Owner'S Manual, Page: 22 / 32

22
III. CONTROLS
Although VENTILATOR II is a digital device, it handles much
like an analog effect, with similar convenience and ease of use.
A good way to get to know the device is to start with this setup:
- Set HI / LO GAIN switch to Lo (switch is out)
- Set Fast Speed, Balance, Mix/Dist Lo, Mix/Dist Hi, Slow
Speed, Acceleration and Level to the 12 o’clock position.
- Turn Drive to the far left (off).
- Set the MODE parameter to KEY (far right position) for an
organ, and to GIT2 (12 o’clock position) for guitar.
- Turn the Remote control off by switching to secondary
parameter mode and setting the REMOTE knob to the far right
position.
III.1. SWITCHES / LEDs
BYPASS
This stomp-switch turns the rotary effect on and off. Its red LED
lights up when the effect is actice. In Bypass the input signal is
relayed to the outputs via a true bypass circuit.
SLOW / FAST
This stomp-switch determines the speed of the rotary effect by
switching between slow and fast. As on the original, the bass
and treble rotors run out of sync at slightly different speeds.
Acceleration and deceleration times also differ, with the bass
rotor taking much longer to speed up and slow down.
STOP
This switch stops the rotors completely. The Stop position is
always with the rotors facing forward.