Inclusion/Exclusion
On factory default the device does not belong to any Z-Wave network. The device needs to be
added to an existing wireless network
to communicate with the devices of this network.
This process is called
Inclusion
.
Devices can also be removed from a network. This process is called
Exclusion
. Both
processes are initiated by the primary controller of the Z-Wave network. This controller is
turned into exclusion respective inclusion mode. Inclusion and Exclusion is then performed
doing a special manual action right on the device.
Inclusion
Press the code button in PIR sensor three times continuously
Exclusion
Press the code button in PIR sensor three times continuously
Product Usage
Battery Usage Tips
Battery life of motion sensor is approximately 1 year. The power level of battery would be
displayed in the gateway. Red icon means the battery needs replacing, and then mobile app
would receive a message “power level is low, please remember to replace battery” from
gateway. In order to avoid false alarm, before replacing battery, please disconnect association
of motion sensor with other devices.
Note
: PIR motion sensor is powered by battery, and please use battery in a correct way to
avoid exploding. When handling the battery, refer to environmental law please.
LED Indicator
- Blink 5 Times (1s Interval): Motion Sensor(PIR) is powered on, and has not added to Z-
Wave network yet
- Blink 5 Times (500ms Interval) Enter includsion mode, excluison mode or send Node Info
- Blink 5 Times (300msInterval) Motion Sensor(PIR) has already added to Z-Wave network,
and make it powered on again
- Blink 1 Time first, then 5 times on and off alternately. Press and hold the reset button for 10
- 15 seconds to restore PIR sensor to factory settings
- Blink 1 Time 1: Detect a Movement
2:Press the Button shortly to Send Wake up information to gateway