7.
Once the interface is connected to the radio, you will need to test the operation of
the interface before re-assembling the dash.
8.
Turn your car stereo on and switch it over to the CD Changer mode using the
Disk / Mode / CD / AUX (depending on the stereo type) buttons on your car
stereo until it shows Disk 1, Track 01 on a the display. Follow the operation
instructions in sections
2.4 – 2.6
to test the interface.
9.
Once the operation of the interface is confirmed, you may continue with the
installation. If you experience difficulties with the installation, please see our
troubleshooting section
.
10.
Find a place where you can place the NEO Bluetooth adapter. We recommend
placing the module in a place that is easily accessible.
Note: Make sure you mount the NEO Bluetooth adapter in a place with enough
room so that, when you re-mount the car stereo, you do not break the adapter.
11.
You may use the glove box or other spaces inside the dash to direct Audio cables
to a convenient location.
12.
Re-mount your car stereo, making sure its clips or strews are secure.
Congratulations!
You have installed the Neo Bluetooth adapter. You may now use it
with your cellular device.
2.4 Pairing with the Phone
You will need to pair your phone with your Bluetooth receiver only once.
1.
Please make sure that Bluetooth function on your phone is active or turned
on and that the phone is set to be discoverable mode before turning the
key. Refer to your phone’s user manual to learn how to turn on and initiate
the pairing feature.
2.
Turn ON vehicle and radio. The Neo Bluetooth will become discoverable
by your phone for 3 minutes. You must pair your phone within that
interval.
3.
The pairing needs to be performed only once. After pairing is completed
your phone will automatically connect to the interface each time the
ignition is turned on (whether radio on or off).
NOTE1
:
Your phone can ask for confirmation and you can get the pop-up message
“Confirm that the passkey “…” is shown on GROM-CAR”. Click “PAIR”
then. A random pin will pop up; you should only have to press Connect.
NOTE2:
Certain vehicle electrical systems may activate the interface upon vehicle
unlock.
