E.
Connect the 12V constant wire and red power wire (can also be yellow) (5) on
NIS02 harness using the Posi-Tap. Please refer to the scheme below for the proper
connection (scheme 1).
Scheme 1. How to connect the wires using Posi-taps.
The wire (the 12V constant wire) that comes from your stereo is the “HOT” wire
referring to the scheme 1.
Attention: Don’t forget to strip the red power wire on your vehicle specific harness
NIS02.
WARNING! NEVER CUT ANY WIRES THAT COME FROM YOUR STEREO!
5.
Connect the Bluetooth dongle 8 pin connector to the EXT1 port of the module.
Mount the dongle module away from metal structures in the dash and as close to
the phone as possible.
6.
Choose a proper mounting location for the microphone such as near the rear view
mirror or sun visor. Avoid mounting the microphone by the side windows to
eliminate extra noise. Please also avoid mounting behind visor to avoid blocking
voice from reaching the microphone. Carefully route the microphone cable to
where the module is installed. Connect the microphone to the female audio plug
on the bluetooth dongle. Make sure the mic is connected securely and all the way
into the 3.5mm port (see picture below).
