9
English
PRODUCT DESCRIPTION
Countertop: appliance to store at negative temperature, fresh ice creams, sorbets and foods suitable to be stored at
the temperature granted by this machine.
The storage temperature is regulated by an electronic programmer. The storage is supplied with four stainless steel
pans with a capacity of 2.5 l each (1/4 Gastronom) or 3 pans of 3.4l + 1 of 2.5l.
Technical data is reported on the plate on the back of the device.
INSTALLATION
• Remove device from packaging. The packaging materials must be disposed selectively on the basis of their
composition.
•
Place the device on a flat surface, away from heat and sunlight. Ensure that the ventilation grill at the base of the
device is not obstructed. Leave a minimum distance of 20 cm from walls or other surrounding objects.
• Clean the device inside with lukewarm water and neutral soap, using a non-abrasive sponge, and dry with a soft
cloth.
• For a proper sanitization carefully follow the provisions of hygiene standards applicable in your country (HACCP or
equivalent).
• Clean the device outside with a damp cloth and detergent suitable for cleaning surfaces, dry with a soft cloth.
USE
•
Connect the power cable (12) to the socket (11). Insert the plug into the appropriate electrical socket and press the
main switch (1).
• The electronic thermoregulator (13) will show the temperature in the tank.
•
The compressor cooling system starts operating after 5 minutes. The light (2) will flash for 5 minutes, until the
compressor starts, and then become fixed. At the same time, the light (8) will turn on, indicating that the ventilation
inside the tank is on.
•
The temperature gradually decreases. Once the set temperature is reached, the compressor stops and the lights
(2) and (8) will turn off. Wait for the appliance to reach the set operating temperature before introducing the product.
•
The compressor will turn on again when the temperature measured in the tank differs by 2°C more than the set one.
•
By pressing the on/off button (7) for 2 seconds, the storage can be turned off or on, making sure that the main switch
(1) is in the ON position
SETTING UP THE TEMPERATURE
Countertop temperature is selected by the manufacture at -12°C.
How to change countertop temperature:
•
press the “SET” button (6) for 3 seconds, the display will show the message “UnL”, briefly press the “SET” button
(6) again and the set storage temperature will appear on the display. Now you can change the storage temperature.
NOTE:
if the device remains inactive for more than 30 “, the display will automatically block the functions by showing
the message« LoC »for a few seconds.
• Repeat the procedure to unlock the display and access the operating temperature setting.
•
Press the button (6): the light (2) will start flashing.
• Press button (3) to decrease and button (4) to increase the temperature. Variations can be made within a limited
adjustment range, between -10°C and -16°C.
•
Press the button (6) once or wait 15 seconds; the led (2) will stop, the new parameter will be memorized and the
electronic programmer will return to indicate the temperature of the tank. In 15 “the device will automatically lock
the display.
ATTENTION:
the counter for storage is not suitable for freezing products but only serves to keep them frozen. On
one side of the tank, under the gelato pans, there is a fan that allows air to circulate to keep the internal temperature
uniform. The fan is activated by the thermal regulator light (8) and stops each time the cover (5) is opened.
MAINTENANCE
• Cleaning the cabinet:
clean using a damp cloth and detergent suitable for cleaning the surfaces and dry with a
soft cloth.
• Cleaning the tank:
clean the internal tank with warm water and neutral soap using a non-abrasive sponge and dry
with a soft cloth. For correct sanitation, strictly follow the hygiene regulations in force in your country (HACCP or
equivalent).
