10
English
DEFROST:
IMPORTANT: the appliance has manual defrosting.
When the formation of ice on the walls of the tank exceeds the thickness of 0.5cm, it is necessary to defrost in order
not to compromise the thermal efficiency of the storage.
Proceed as follows:
• Remove the plug from the socket.
• Transfer the product stored in the trays to another suitable storage device.
• Place the container (10) under the collector (9) located under the storage case.
•
Remove the drain plug (9) and let the internal ice melt and the water flow from the drain (9). Dry thoroughly.
• When the tank is completely dry, put the plug into the socket.
• Wait for the appliance to reach operating temperature before placing trays with gelato.
• Never use a metal or sharp tool to remove ice.
EFFICIENCY
To maintain the device efficiency operation, clean the condenser regularly. This operation falls outside normal mainte
-
nance and should be performed by a qualified technician, who should proceed as follows:
• Switch off the machine by the switch (1) and remove the plug from the electrical socket.
•
Clean the condenser with a brush, air jet or suction device to avoid damaging the device.
• Restart the storage unit.
POSSIBLE PROBLEMS
The countertop is not running, programmer is not light up.
•
The plug (12) has not been connected to power supply socket (11).
• Back button is switched off.
The storage is not working, programmer is light up.
• The control system waits 5 minutes before restarting the compressor
• The storage was turned off and an attempt was made to restart it immediately.
Compressor stay always switched on, or it switch on and off frequently.
•
The room temperature is above 30 ° C.
•
Excessive quantity of gelato has been placed in the storage and the mass is not yet at the correct temperature.
• The ventilation grilles (14) are blocked
Vibrations.
• Check that the storage is in a horizontal position.
The storage case makes too much noise.
•
The noise may come from the flow of refrigerant gas, this is normal.
•
The contraction and expansion of the internal walls can cause creaking.
• The storage is not in level position.
The electronic programmer is not working properly.
• If an error message other than those described in this manual appears on the display, contact an authorized Service
Center.
