7
It is recommended to wear a P2 filter-class respirator. Observe the relevant regulations in your country
for the materials to be worked.
OPERATION
1. Inserting the battery
Use only the lithium-ion battery from the original factory with the voltage listed on the nameplate of
your power tool.
Using other batteries can lead to injuries and pose a fire hazard.
Note:
Use of batteries not suitable for the machine can lead to malfunctions of or cause damage to the
power tool.
Set the rotational direction switch (8) to the center position in order to avoid unintentional starting.
Insert the charged batteries (7) from the bottom of the base of the power tool. Push the battery
completely vertical to the base until the battery is pushed to the limit, then rotate the locking ring until
it is securely locked.
Attention:
Make sure that the battery is inserted correctly into the power tool.
2. Reversing the rotational direction
The rotational direction switch (8) is used to reverse the rotational direction of the machine. However,
this is not possible with the On/Off switch (9) activated.
Right rotation:
For drilling and driving in screws, push the rotational direction switch (8) left to the stop.
Left rotation:
For loosening and unscrewing screws and nuts, press the rotational direction switch (8)
through to the right stop.
Middle option:
There is an option to place the rotational direction switch (8) in the middle; this option
operates only the LED flashlight, without any rotation of the drill.
3. Setting the torque
With the torque presetting ring (2), the required torque setting can be pre-selected to 16 settings. With
the correct setting, the insert tool is stopped as soon as the screw is screwed flush into the material or
when the adjusted torque is reached. The safety clutch is deactivated in the “
” position, e.g. for
drilling. Select a higher setting or switch to the “
” symbol when unscrewing screws.
