Nemesis UV-C Tower User Manual_V1
_________________________________________________________________________________________
_________________________________________________________________________________________
9
CONNECTING YOUR Wi-Fi DEVICE
WARNING: Pressing the button on your Wi-Fi unit for less than 5 seconds will turn the Tower on.
1.
Turn the Wi-Fi unit to Hot Spot Mode
a.
Hold the button for 5 seconds, the blue indicator light should blink two short,
one long
b.
Press button again, and hold for 5 seconds until the blue indicator flashes
continuously
2.
Then connect to the device’s Wi-Fi through your phone
i.
ITEAD-##########
ii.
Password:12345678
3.
Go to the UV Inc Application
4.
Hit the + button in the bottom center
5.
Press ‘
Compatible Mode
’ at the bottom of the screen
6.
Press “Next”
7.
Set the network you would like to control your Tower from by entering it here
a.
NOTE: 2.4 GHZ Wi-Fi is required for these devices
8.
Press “Next”, then press “Connect”
9.
In your device settings to connect to the ITEAD-########## device
10.
Once connected, the “Connect” button should read “Next”
11.
The device will begin to configure, then when asked to connect the device to the Wi-Fi
network, press “Accept”
12.
The device will take a few minutes to fully configure into the network, leave your Tower
connected to power for a few minutes after this step.
APP USE
1.
After setup, you will be prompted to name your Tower
2.
On the Home Screen, your newly connected Tower should appear.
3.
Tapping on that Tower will open a second menu, from here you can
a.
Power on your Tower
b.
Set a schedule
c.
Set a Timer
d.
Set a Loop Timer
e.
If needed, you can update your device from here as well:
i.
Press the “…” button in the top right of your screen
ii.
From here you will open the settings, and an option to update to the
current software version will be available.
