Part 2 Technical Manual Of Motherboard
27
Use this item to select an optimal setting for super IO device.
Transmission Mode Select
The optional settings are: [RS422]; [RS232]; [RS485].
Mode Speed Select
The optional settings are: [RS232/RS422/RS485=250kbps];
[RS232=1Mbps, RS422/RS485=10Mbps].
Serial Port FIF0 Mode
The optional settings are: [16-Byte FIF0]; [32-Byte FIF0]; [64-Byte FIF0];
[128-Byte FIF0].
ERP Support
The optional settings: [Disabled]; [Enabled].
This item should be set as [Disabled] if you wish to have all active
wake-up functions.
Case Open Detect
This item controls detect case open function.
The optional settings: [Disabled]; [Enabled].
WatchDog Timer
Use this item to enable or disable WatchDog Timer Control. When set as
[Enabled], the following sub-items shall appear:
WatchDog Timer Value
User can set a value in the range of [10] to [255].
WatchDog Timer Unit
The optional settings are: [Sec.]; [Min.].
WatchDog Wake-up Timer
This item support WDT wake-up while ERP function is set as [Enabled].
The optional settings: [Disabled]; [Enabled].
When set as [Enabled], the following sub-items shall appear:
WatchDog Wake-up Timer Value
The setting range is [10] ~ [4095] seconds, or [1] ~ [4095] minutes.
WatchDog Wake-up Timer Unit
The optional settings are: [Sec.]; [Min.].
ATX Power Emulate AT Power
This item displays current Emulate AT Power Status, motherboard power
On/Off control by power supply. User needs to select ‘AT or ATX Mode’
on MB jumper at first
(refer to
Page 9
,
Pin (1&2) of J1
for ATX Mode & AT
Mode Select).
Serial Port Console Redirection
Press [Enter] to make settings for the following sub-items:
COM1
Console Redirection