![background image](http://html1.mh-extra.com/html/nelson/n1500i/n1500i_operating-manual_3935761030.webp)
N1500i FACS Manual
23
Part No. 729-110-053 V.1.03
© 2018 Nelson Stud Welding, Inc. All rights reserved.
preset is selected, the time and current are displayed on the front
panel, and the LED on the selected preset key lights.
Users are not restricted to pre-programmed presets, but may save
more usable weld settings. To do so, first select the desired time and
current settings using the corresponding Up/Down arrow. Then press
and hold the desired preset key for 4 seconds. The preset values will
be replaced by the desired custom values. When the orange LED of
the preset button being pressed turns ON, the selected preset has
been successfully programmed.
The weld parameter presets depend on the selected weld method (short
cycle, drawn arc).
3.3.6 Recommended Weld Parameters
The values specified in the tables and diagrams must be used only as
guide values, which were developed under optimized welding
conditions.
The best possible weld parameters will be determined with proper
attention to factors such as the material and surface quality of the
workpiece, plate thickness, welding position, stud type, stud
dimensions, etc. in trial welds.
The trial welds will allow qualification of weld parameters which factor
in the real conditions in the current production process.
Upon suspicion of faulty welds, the settings on the welding unit and
the weld gun should be reviewed.
The weld parameters in the tables and in Stud Expert are provided as
is, without warranty of any kind, either expressed or implied, including,
but not limited to, the implied warranties of merchantability and fitness
for a particular application. Performance suitability for any specific
application should be determined by the user. The user assumes all
liability of the use or the results of the use of the recommended weld
parameters.
Nelson cannot assume any responsibility for updating or correcting the
welding advice or guide values, once they have been given. Nor does
the provision of information create, expand or alter any warranty with
respect to the sale of our products.
Note!
Note!