6
Messager USB Duo Installation:
The Messager USB Duo should be installed using the following steps:
Step 1:
Wall or shelf mount the Messager USB Duo near the incoming phone lines. Screws and rubber feet are
supplied in the accessory kit.
Step 2:
Attach the antenna by screwing it onto the ANT jack (If not already attached).
Step 3:
Connect the incoming phone lines to the TELCO IN jack.
Duo Wireless Adapter Installation:
The Duo Wireless Adapter should be installed using the following steps:
Step 1:
Place a Duo Wireless Adapter next to each phone.
Step 2:
Plug the attached power pack to a wall outlet.
L1
L2
L1\2
Splitter
Female-to-female
in-line adapter
12VDC
500mA
+
VOLUME
ANT
TELCO
IN
PHONE
OUT
+
Step 4:
Connect the wire going to the phones throughout the building to the PHONE OUT jack.
Step 5:
Attach the included power pack to a wall outlet, then attach the other end to 12VDC jack.
Step 6:
Plug the USB stick that was included with the unit into the USB jack on the front of the unit.
Step 7:
Adjust the volume level with pot labeled VOLUME on the rear of the unit. Call into the phone system
and be placed on hold to fine tune volume. Volume up is clockwise, volume down is counter-clockwise.
If this is a two-line installation AND both lines are on seperate wires then see the diagram below. If both
lines are already on one wire then skip this section. The accessory kit includes a splitter, in-line adapter and
cable to allow the lines to be combined onto one wire. This step will place Line 1 on the center two pins
and Line 2 on the two outside pins of the plug being inserted into the TELCO IN jack.
6" RJ-11 Cable
Incoming Telco Lines
