Neilsen CT3320, Instruction Manual

Page: 11 / 16

9
8. LUBRICATION AND MAINTENANCE
8.1. Disconnect the air supply from the tool before lubricating.
8.2. Your tool requires lubrication before you use it for the first time.
8.3. Wipe off excessive oil at the exhaust. Excessive oil will damage o-rings of
tools. If in-line oiler is used, manual lubricating through the air inlet is not required
on a daily basis.
8.4. Turn the tools so the inlet is facing up hand put one drop of high-speed
spindle oil. Never use detergent oil or additives. Operate the tool briefly after
adding oil.
CLEARING A JAMMED FASTENER
▲
Disconnect air tool from air hose.
▲
Pull back the pusher until it latches at the end of the magazine.
▲
Remover jammed fastener.
▲
Press the latch button and slide the pusher forward.
EVERY-DAY MAINTENANCE CHECKS
Before connection to the air supply:
. Drain the compressor reservoir of condensate.
. Drain the air lines of condensate.
. Drain the combined separator filter, regulator,water trap.
. Fill up the combined separator filter, regulator, lubricant reservoir.
. Check the line pressure is correct for the tool.
9. DISPOSAL
At the end of the machine's working life, or when it can no longer be repaired,
ensure that it is disposed of according to national regulations.
Contact your local authority for details of collection schemes in your area.
In all circumstances:
Do not dispose of this tool with domestic waste.
Do not incinerate.
During decommissioning of the equipment, certain hazards should be understood and
avoided:
. Only with the line pressure released shall the equipment be disassembled.
.Goggles should be worn.