8
accessory must be rated to at least the maximum speed of the Die Grinder.
3. Use the Wrench to hold the Spindle in place, while tightening the
Collet Cap .
WARNING!
Do not use with cutoff wheels, saws or any attachment that requires
safety guard. This tool does not have a safety guard.
Adjusting the Air Flow
Rotate the Regulator Knob to adjust the amount of air flow from lowest to
highest (1 to 4 on the Knob).
Work Piece and Work Area Set Up
1. Designate a work area that is clean and well-lit. The work area must
not allow access by children or pets to prevent distraction and injury.
2. Route the air hose along a safe route to reach the work area without
creating a tripping hazard or exposing the air hose to possible damage. The
air hose must be long enough to reach the work area with enough extra length
to allow free movement while working.
3. Secure loose workpieces using a vise or clamps (not included) to prevent
movement while working.
4. There must not be hazardous objects (such as utility lines or foreign objects)
nearby that will present a hazard while working.
General Operating Instructions
Note: Make all set up adjustments to tool before connecting air supply.
1. If an automatic oiler is not used, add a few drops of Pneumatic Tool
Oil to the airline connection before use. Add a few drops more after
each hour of continual use.
2. Mark the workpiece area where you wish to grind.
3. With both hands, grip the Die Grinder so that your thumbs rest on the
Throttle and Safety Lock.
4. Keep the accessory off the surface of the workpiece until it reaches
operating speed.
5. Press the Safety Lock forward while pressing down on the Throttle.
NOTE:
The Die Grinder’s speed is variable. Vary the pressure placed on the
Throttle to vary the speed of the tool. Use only enough speed as needed to
cut the workpiece.
6. Slowly and carefully place the accessory onto the surface of the workpiece.
7. Keep steady pressure, but do not force the tool, as you will stall the unit.
Use only enough pressure to do the job properly.
8. The tool
’
s air flow can be controlled with the Regulator Knob on the unit
