7
23. Assemble two corner caps to the front of the cart using four M6X16 round head bolts , Ø6 lock
washer, Ø6 Flat Washer and M6 hex nuts. Tighten. See
Figure 9.
24. Assemble the tie rod to the axle spindles using two M12X30 hex bolts, four Ø12 flat washer and two
M12 hex lock nuts, Tighten, leavind ollse enough that the spindles still pivot. See
Figure 10.
25. Remove the M12 lock nut from the center pivot bolt. Assemble rear tongue section, the pivot bushing,
the large Ø12 flat washer and M12 hex lock nut onto the pivot bolts as shown in
Figure 11
.(The pivot
bushing fits into the hole in the tongue.) Tighten.
26. Fasten the tongue to the tie rod as shown in Figure 11,using a M12X30 hex bolt, two Ø12 flat washer
and a M12 hex lock nut . Tighten, leaving loose enough that the tongue can pivot.
27. Apply grease to the axle spindles now or use a grease gun after wheels are assembled.
28. Assemble a cotter pin to the inside hole in an axle spindle. Place a Ø20 Flat Washer, a wheel
(valvastem facing out) and another Ø20 Flat Washer onto the axle spindle. Assemble a cotter pin to
the end hole in the axle. Repeat on other side. See
Figure 12
. Note: Prevent the axle spindle from
pivoting downward until the wheel is secures to it by the outer cotter pin.
29. Assemble a hub cap over the Ø20 Flat Washer on each wheel. See
Figure 12.
FIGURE 8
FIGURE 9
FIGURE 7
FIGURE 10