9
STEP 8: ADJUSTABLE. When you finished all above steps, if you find the three big holes at
the bottom of hopper just match the three holes of adjustable plate. You don't need to do
the following steps. If they are not match neatly, you may need to do the following steps.
(1)Release two bolts M5x10 on clamp as shown.
(2). Push the handle to the lowest position <downwards>, use your hand to adjust the
adjustable plate so as to make sure three big holes at the bottom of hopper just match the
threes holes of adjustable plate neatly.
(3). And then tight the bolts and nuts on clamp again.
(4)To operate this spreader, push the handle to the top position (upwards). You may move
the position of Wing nut on Gauge & Lever to adjust the spacer of three holes between
hopper and adjustable plate as per your need when spreading.
Summary of Contents for CT2207
Page 11: ...11 PARTS DRAWING...
