11
STEP 6:
ADJUSTMENTS. When you have finished all above steps, and if you
find the holes at the bottom of hopper can close and open completely by using
the handle . You don't need to do the following steps. If it do not close and open
completely, you may need to do the following steps. (1)Release two bolts M5x10
on clamp as shown. (2). Push the handle to the top position, use your hand to
adjust the adjustable plate so as to make sure the hole at the bottom of hopper
can be closed completely. (3). Push the handle to the lowest position, use your
hand to adjust the adjustable plate so as to make sure the hole at the bottom of
hopper can be opened completely. (4). And then tighten the bolts and nuts on
clamp again.
To operate this spreader, push the handle to the lowest position (downwards).
You may move the position of Wing nut on the Gauge & Lever to adjust the
space on the hole between the hopper and the adjustable plate as per your need
when spreading.
