COMPONENTS AND CONTROLS
1. Set-Up
REPOSITIONING BRACKET
1.Remove the Bolts on the Support Post and reposition to move the guide rollers,
if needed, for the desired mounting location (wall, floor or ceiling).
2.Replace the Bolts and tighten.
MOUNTING REEL
1.Choose a mounting location that is free of electrical wiring or other obstructions,
and is sturdy enough to support the weight of the Reel and hose as well as the
force used to extend and retract it.
2.Make a paper template from the mounting plate of the Reel. Mark the center of
the bolt holes in the desired mounting location.
3.Check for hidden wiring, then, drill holes to accommodate 1/2” bolts (not
included).
4.Mount the Reel and secure in place with four bolts.
2. Operation
ADJUST THE SPRING TENSION
1.Pull out approximately six feet of Hose.
2.Remove the Hose Stopper from the Hose and slide the Hose out of the Roller
Guide so the Hose is hanging loose.
a. To increase tension, wrap the loose hose one time around the Reel Drum.
b. To decrease tension, unwrap the hose one time from the drum.
3.Run the hose back through the guide and re-attach the hose stopper.
4.Pull the Hose out several feet to check the tension.
