6
WARNING! Disconnect drill from air supply before changing drill bit,
servicing or performing maintenance.
Replace or repair damaged parts.
Use
genuine parts only. Unauthorised parts may be dangerous and will invalidate the
warranty.
5.1.
If the air supply does not have an oiler, lubricate the drill daily with a few
drops of good grade air tool oil, dripped into the air inlet before use or dispensed
automatically through an air system oiler.
5.2.
Clean the drill after use and change the bit when worn or damaged.
5.3.
Loss of power or erratic action may be due to the following:
a)
Excessive drain on the air supply. Moisture or restriction in the air line.
Incorrect size or type of hose connectors. To remedy check the air supply and
follow instructions in Section 3.
b)
Grit or gum deposits in the drill may also reduce performance. Flush the drill
with gum solvent oil or an equal mixture of SAE No 10 oil and kerosene. Allow to
dry before use.
5.4.
When not in use, disconnect from air supply, clean drill and store in a safe,
dry, childproof location.
5. MAINTENANCE