Neilsen CT1085, Original Instructions Manual

Page: 8 / 12

7
and filter for best service, as shown in the diagram above. An in-line shut off
valve is an important safety device because it controls the air supply even if
the air hose is ruptured.
Note: If an automatic oiler system is not used, add a few drops of Pneumatic
Tool Oil to the airline connection before operation. Add a few more drops after
each hour of continual use.
Attach an air hose to the compressor’s air outlet. Connect the air hose
to the air inlet of the tool. Other components, such as a connector and
quick coupler, will make operation more efficient, but are not required.
WARNING! To prevent serious injury from accidental operation: Do not install
a female quick coupler on the tool. Such a coupler contains an air valve that
will allow the air tool to retain pressure and operate accidentally after the air
supply is disconnected.
Note: Air flow, and therefore Air Angle Die Grinder performance, can be
hindered by undersized air supply components.
2. The air hose must be long enough to reach the work area with enough
extra length to allow free movement while working.
3. Make sure tool’s Control Lever is in the off position; refer to Operation
section for description of controls.
4. Close the in-line safety valve between the compressor and the tool.
5. Turn on the air compressor according to the manufacturer’s directions and
allow it to build up pressure until it cycles off.
6. Adjust the air compressor’s output regulator so that the air output is enough
to properly power the tool, but the output will not exceed the tool’s
maximum air pressure at any time. Adjust the pressure gradually, while
checking the air output gauge to set the right pressure range.
7. Inspect the air connections for leaks. Repair any leaks found.
8. If the tool will not be used at this time, turn off and detach the air supply,
safely discharge any residual air pressure, and release the throttle to
prevent accidental operation.
OPERATING INSTRUCTIONS
Read the entire Important Safety Information section at the
beginning of this manual including all text under subheadings
therein before set up or use of this product.
Inspect tool before use, looking for damaged, loose, or missing