5
SPECIFICATION
Belt size: 10 x 330mm
Operating air pressure: 90 Psi (6.3 Bar)
Average air consumption: 6 cfm
Free speed: 16000 rpm
Hose Size: 3/ 8"
Air inlet: 1/ 4" BSP
PREPARING FOR USE
Air Supply
(Recommended hook-up procedure is shown in fig.1).
1. Ensure the sander air valve (or throttle) is in the "off" position before connecting to the air
supply.
2. You will require an air pressure between 70-90psi, and an air flow of 6cfm.
3.
WARNING!
Ensure the air supply is clean and does not exceed 90psi.
Too high an air pressure and unclean air will shorten the product life due to excessive wear,
and may be dangerous causing damage and/or personal injury.
4. Drain the air tank daily. Water in the air line will damage the sander and will invalidate your
warranty.
5. Clean compressor air inlet filter weekly.
6. Line pressure should be increased to compensate for unusually long air hoses (over 8
metres).The minimum hose size should be 3/8
” I.D. and fittings must have the same inside
dimensions.
7. Keep hoses away from heat, oil and sharp edges. Check hoses for wear, and make certain
that all connections are secure.
Couplings
Vibration may cause failure if a quick change coupling is connected directly to the air sander. To
overcome this, connect a leader hose to the sander. A quick change coupling may then be used
to connect the leader hose to the air line recoil hose. See figs.1 & 2.
OPERATING INSTRUCTIONS
1. Unpack the product and check contents against the parts listed below. If there is anything
damaged or missing contact your supplier immediately.
WARNING!
Ensure that you have read and understood the safety instructions in
Section
“SAFETY WARNINGS”.
