![background image](http://html.mh-extra.com/html/neilsen/ct0878/ct0878_original-instructions-manual_717830007.webp)
6
more efficient, but are not required.
WARNING!
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:
Do not install a female quick coupler on the tool. Such a coupler contains an air valve that will
allow the air tool to retain pressure and operate accidentally after the air supply is
disconnected.
Note:
Air flow, and therefore tool performance, can be hindered by undersized air supply
components. The air hose must be long enough to reach the work area with enough extra
length to allow free movement while working.
3. Release the Trigger; refer to Operation section for description of controls.
4. Close the in-line shutoff valve between the compressor and the tool.
5. Turn on the air compressor according to the manufacturer's directions and allow it to build up
pressure until it cycles off.
6. Adjust the air compressor's output regulator so that the air output is enough to properly
power the tool, but the output will not exceed the tool's maximum air pressure at any time.
Adjust the pressure gradually, while checking the air output gauge to set the right pressure
range.
7. Inspect the air connections for leaks. Repair any leaks found.
8. If the tool will not be used at this time, turn off and detach the air supply, safely discharge
any residual air pressure, and release the Trigger to prevent accidental operation.
Note:
Residual air pressure should not be present after the tool is disconnected from the air
supply. However, it is a good safety measure to attempt to discharge the tool in a safe fashion
after disconnecting to ensure that the tool is disconnected and not powered.
OPERATING INSTRUCTIONS
Read the
ENTIRE IMPORTANT SAFETY INFORMATION
section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
Inspect tool before use, looking for damaged, loose, and missing parts.
If any problems are found, do not use tool until repaired.
TOOL SET UP
WARNING!
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION: Turn off
the tool, detach the air supply, safely discharge any residual air pressure in the tool, and
release the throttle and/or turn the switch to its off position before performing any