POWER TOOL USE AND CARE
Do not force the power tool. Use the
correct power tool for your application.
The correct power tool will do the job better
and safer at the rate for which it was
designed.
Do not use the tool if the switch does not
turn it ON or OFF.
Any power tool that
cannot be controlled with the switch is
dangerous and must be repaired.
Disconnect the plug from the power
source before making any adjustments,
changing accessories or storing power
tools.
Such preventive safety measures
reduce the risk of starting the power tool
accidentally.
Store idle power tools out of the reach of
children and do not allow persons
unfamiliar with the power tool or these
instructions to operate the power tool.
Power tools are dangerous in the hands of
untrained users.
Maintain power tools. Check for
misalignment or binding of moving parts,
breakage of parts and any other condition
that may affect the power tools operation.
If damaged, have the power tool repaired
before use.
Many accidents are caused by
poorly maintained power tools.
Keep cutting tools sharp and clean.
Properly maintained cutting tools with sharp
cutting edges are less likely to bind and are
easier to control.
Use the power tool, accessories and tool
bits etc., in accordance with these
instructions and in the manner intended
for the particular type of power tool,
taking into account the working
conditions and the work to be performed.
Use of the power tool for operations different
from intended could result in a hazardous
situation.
SERVICE
Tool service must be performed only by
qualified personnel.
Service or
maintenance performed by unqualified
personnel could result in risk of injury.
When servicing a tool, use only identical
replacement parts. Follow instructions in
the Maintenance section of this manual.
Use of unauthorized parts or failure to follow
Maintenance instructions may create a risk of
electric shock or injury.
SPECIFIC SAFETY RULES
For your safety, do not plug in your
charger or install the battery in the tool
until you have read and understood this
Owner’s Manual.
WEAR EYE PROTECTION
. Use face or
dust mask along with safety goggles if
operation is dusty. Use hearing
protection, particularly during extended
periods of operation, wear safety shoes.
“Wear ear protectors with impact
drills.
Exposure to noise can cause
hearing loss”
DO NOT
wear gloves, jewellery, neckties
or loose clothing.
DO NOT
drill, cut or sand material too
small to be securely held.
ALWAYS
keep hands out of the path of
the impact wrench square anvil. Avoid
awkward hand positions where a sudden
slip could cause your hand to move into
the path of the anvil, socket or bit.
SECURE WORKPIECE
. Use clamps or
a vice to hold the work when practical. It
is safer than using your hand and it frees
both hands to operate the tool.
POWER TOOL SAFETY
5
WARNING
!
SAVE THESE INSTRUCTIONS FOR REFERENCE
