NEFF T26CA Series, Instruction Manual

Page: 6 / 16

en
Gas burners
6
Residual heat indicator
Every hotplate on the hob has a residual heat indicator
that indicates whether it is hot or warm.
If
•
appears in the display the hob is still hot. As the
hotplate cools down further, the display changes to
œ
.
The display remains lit until the hotplate has cooled
sufficiently. Do not touch the respective hotplate if this
indicator is lit.
Accessories
Depending on the model, the hob may include the
following accessories. These can also be acquired from
the Technical Assistance Service.
--------
Code
The manufacturer accepts no liability if these
accessories are not used or are used incorrectly.
Ä
Gas burners
Gas burne rs
Switching on manually
1.
Press the control knob for the selected burner and
turn it anticlockwise to the highest power setting.
2.
Hold an igniter or a naked flame (such as a lighter or
a match) against the burner.
Automatic ignition
If your appliance has automatic ignition (ignition plugs):
1.
Press the control knob for the selected burner and
turn it anticlockwise to the highest power setting.
Sparks are produced on all burners while you are
pressing and holding the control knob and the
³
symbol appears on the display. The burner ignites.
2.
Release the control knob.
3.
Turn the control knob to the required position.
If the burner does not ignite, switch it off and repeat the
steps described above. This time, hold the control knob
down for longer (up to 10 seconds).
:
Warning – Risk of deflagration!
If the burner does not switch on after 10 seconds,
switch off the control knob and open the door or
window in the room. Wait at least a minute before
igniting the burner again.
Note:
It is important to keep the appliance clean. If the
ignition plugs are dirty, this may cause ignition faults.
Clean the ignition plugs regularly with a small non-
metallic brush. Take care to prevent the ignition plugs
from suffering any heavy knocks.
Safety system
Your hob is equipped with a safety system
(thermocouple) that cuts off the gas when the burners
are accidentally switched off.
To ensure that this device is active:
1.
Switch on the burner as usual.
2.
Without releasing the control knob, press and hold it
down firmly for 4 seconds after lighting the flame.
Switching off a burner
Turn the control knob clockwise to position 0. The ‹
symbol will appear in the display and the residual heat
indicator will appear after a few seconds.
A few seconds after the burner is switched off, a sound
(thud) will be produced. This is not a fault - this means
that the safety device is no longer operating.
Warnings
It is normal to hear a soft whistling noise while the
burner is operating.
When first used, it is normal for the burner to give off
odours. This does not pose any risk and does not
indicate a malfunction. They will disappear in time.
Additional wok pan support
Only for use on wok burners
with pans with a round base.
The additional wok pan support
should be used to prolong the
appliance's useful life.
Additional support for
espresso makers
Only when using cookware with
a base less than 12 cm in diam-
eter on the smallest burner.
Z2471X0 Additional wok pan support: cast iron
(4-5 kW)
Z2472X0 Wok attachment: Cast iron (mini-wok
burner)
Z2402X0 Additional coffee maker support