Automatic switch-off
en
35
9 Automatic switch-off
If you do not change the settings of a hotplate for a
long time, automatic switch-off will be activated.
When the hotplate switches off depends on the heat
setting selected (1 to 10 hours).
The heat to the hotplate is switched off.
and the re-
sidual heat indicator / flash alternately on the hot-
plate display.
9.1 Continuing cooking after automatic
switch-off
1.
Touch any control.
a
The display goes out.
2.
Reset.
10 Keep-warm function
The keep-warm function allows you to melt chocolate
or butter and to keep food or cookware warm.
10.1 Switching on the keep-warm function
1.
Select the hotplate.
2.
Touch the symbol.
a
lights up on the heat setting display.
10.2 Switching off the keep-warm function
1.
Select the hotplate.
2.
Touch the symbol.
a
lights up on the heat setting display.
11 Wipe protection
Wiping over the control panel while the hob is switched
on may alter settings. Your hob has a wipe protection
function to prevent this.
The main switch is excluded from the wipe protection
function. You can switch the hob off at any time.
11.1 Activating wipe protection
▶
Touch .
a
A signal sounds.
a
The indicator lamp above lights up.
a
The control panel is locked for 30 seconds.
12 Energy consumption display
This function indicates the total amount of energy con-
sumed between switching the hob on and switching it
off again.
Once switched off, the energy consumption is dis-
played in kilowatt hours, e.g. 1.08 kWh, for
10 seconds.
The accuracy of the display depends on various factors
such as the voltage quality of the power supply.
The display can be activated in the basic settings.
13 Basic settings
You can configure the appliance to meet your needs.
13.1 Overview of the basic settings
You can find an overview of the basic settings and the
default factory settings here.
Dis-
play
Selection
Automatic childproof lock
– Switched off
1
– Switched on
– Manual and automatic childproof lock are
switched off.
1
Factory setting
Dis-
play
Selection
Audible signal
– Confirmation signal and operating error
signal are switched off. The main switch sig-
nal remains switched on.
– Only the operating error signal is
switched on.
– Only the confirmation signal is switched
on.
– Confirmation signal and operating error
signal are switched on.
1
1
Factory setting
Summary of Contents for T18 D.6 Series
Page 2: ...cm 2 T18 D 6 21 12 17 26 5 23 18 14 5...
Page 51: ......
