en
Installation instructions
18
2.
Loosen the screws on the side covers.
20
3.
Open the odour filter cartridge.
4.
Push the side covers inwards and remove them.
5.
Close the odour filter cartridge.
Hanging the appliance
1.
Lift the appliance by the corners and turn it over.
2.
Position the cable that is provided on-site in the
marked area on the appliance.
3.
Guide the cable that is provided on-site through the
opening and hook the appliance into the fastening
screws on the ceiling.
4.
Push the appliance as far as it will go into the four
key hole openings using the guide sleeves.
5.
Move the appliance and lower it further so that the
collar nuts are positioned on the edge of the guide
sleeves.
6.
Carefully tighten the diagonally opposite collar nuts
until the appliance is flush-mounted on the ceiling.
13
Tighten the collar nuts one at a time so that the ap-
pliance does not tilt when doing so.
Connecting the appliance
Requirement:
Ensure that the protection against con-
tact is guaranteed during installation.
1.
Guide the cable that is provided on-site through the
opening in the appliance.
Maintain the bending radius of the cable that is
provided on-site for connecting the appliance.
The cable must remain doubly insulated. You should
therefore strip the cable as little as possible up-
stream of the connecting terminal.
Summary of Contents for I16RPS8S5
Page 1: ...Ceiling mounted ventilation system User manual and installation instructions I16RPS8S5...
Page 22: ......
Page 23: ......
