background image

 Environmental protection  

en

5

7

Environmental protection

Environmen

tal prote

ction

Environmentally-friendly disposal

Dispose of packaging in an environmentally-friendly 

manner.

Ç

Operating modes

Operating

 modes

Exhaust air mode

Note: 

The exhaust air must not be conveyed into a 

functioning smoke or exhaust gas flue or into a shaft 

which is used to ventilate installation rooms which 

contain heat-producing appliances.

Before conveying the exhaust air into a non-

functioning smoke or exhaust gas flue, obtain the 

consent of the heating engineer responsible.

If the exhaust air is conveyed through the outer wall, 

a telescopic wall box should be used.

Circulating-air mode

Notes

To bind odours in circulating-air mode, you must 

install an activated carbon filter. The different options 

for operating the appliance in circulating-air mode 

can be found in the brochure. Alternatively, ask your 

dealer. The required accessories are available from 

specialist retailers, from customer service or from 

the Online Shop.

For appliances with an additional internal filter, only 

the CleanAir recirculation module (see Accessories 

for circulating-air mode) can be used.

1

Operating the appliance

Operating

 the appl

iance

These instructions apply to several appliance variants. It 

is possible that individual features are described which 

do not apply to your appliance.

Note: 

Switch on the extractor hood when you start 

cooking and switch it off again several minutes after you 

have finished cooking. This is the most effective way of 

removing the kitchen fumes.

Control panel model 1

Control panel

Setting the fan

Switching on the appliance

Press the 

#

 button.

The fan starts at setting 

ƒ

.

Press the + or - button to change the fan strength.

Switching off

Press the 

#

 button.

Intensive setting

You can use the intensive setting if there is a large 

build-up of odours and fumes/vapours.
Press the + button when the fan is at setting 

.

The intensive setting

 ˜‚

 is activated. Pressing the + 

button again activates the intensive setting 

˜ƒ

.

After approx. six minutes, the electronics automatically 

reduce the fan to a lower setting . If you want to end the 

intensive setting before the preset time expires, press 

the - button until the required fan setting is reached.

Fan run-on time

Press the - button until 

 appears.

After approx. ten minutes, the fan switches off 

automatically.

This appliance is labelled in accordance with 

European Directive 2012/19/EU concerning 

used electrical and electronic appliances 

(waste electrical and electronic equipment - 

WEEE). The guideline determines the 

framework for the return and recycling of used 

appliances as applicable throughout the EU.

The air which is drawn in is cleaned 

by the grease filters and conveyed to 

the exterior by a pipe system.

The air which is drawn in is cleaned by 

the grease filters and an activated 

carbon filter and conveyed back into the 

kitchen.

Explanation

#

Fan on/off

 -

Reduce the fan settings/fan run-on time/interval ventilation

 +

Increase the fan settings/intensive setting 1, 2

A

Light on/off/dimming

IUHVK

YRO

Summary of Contents for D86EH52N0B/02

















Reviews: