NEFF C67P70N0, Instruction Manual

Page: 16 / 40

16
Changing the basic settings
Requirement: the operating mode selector must not be pushed
in.
1.
Press and hold the ± button for a few seconds.
The first basic setting is displayed on the text display.
2.
Press the ± button repeatedly until the required basic setting
is shown.
3.
Use the temperature selector to make the desired setting.
4.
Press and hold the Info button ± for a few seconds.
Your setting is applied.
You can change the settings at any time.
Pyrolytic cleaning
During pyrolytic cleaning, the cooking compartment is heated
to approx. 480 °C. Any food residues from roasting, grilling
and baking are burnt to ash. The pyrolytic cleaning programme
takes approx. 2 hours, including the heating up and cooling
down times.
Notes
■
For safety reasons, the oven door locks automatically. You
cannot open the oven door again until the cooking
compartment has cooled slightly and the padlock symbol for
the locking mechanism disappears. Do not attempt to push in
the latch by hand.
■
If you open the appliance door again after the appliance has
started, the locking latch may be visible at the top of the
oven. This is normal. The latch disappears automatically
when you close the door. Please do not attempt to push in
the latch by hand.
■
Do not attempt to open the appliance door while self-cleaning
is in operation. The cleaning process may be cancelled.
■
The cooking compartment light remains off during self-
cleaning. The temperature control bars do not appear.
ã=
Risk of fire!
■
The outside of the appliance becomes very hot. Make sure
that nothing is placed against the front of the appliance.
Small children must be kept at a safe distance from the
appliance.
■
Never hang combustible objects, e.g. tea towels, on the door
handle.
Preparation
Take all accessories and ovenware out of the oven.
ã=
Risk of serious damage to health.!
Never use pyrolytic cleaning for cleaning non-stick baking trays
and baking tins. High temperatures damage the non-stick
coating and poisonous gases are released.
ã=
Risk of fire!
Loose food residues, grease and meat juices may catch fire.
Wipe the oven floor, the inside of the oven door and the edges
around the front of the oven with a damp cloth. Do not scour
the oven seal.
It is sufficient to clean the cooking compartment every two to
three months. If requiered, you can clean the oven more
frequently than this. Cleaning only requires approximately
3.8 kilowatt hours.
Setting pyrolytic cleaning
1.
Press the operating mode selector.
“Appliance is ready for use” appears on the text display.
2.
Turn the operating mode selector until the V Pyrolytic
cleaning appears on the text display.
3.
Start the cleaning operation with ƒ .
The oven door locks shortly after operation starts. “Door
locked” appears in the text display.
Once pyrolytic cleaning has finished
Cleaning has finished. The oven stops heating. “Appliance is
ready for use” appears on the text display.
Checking the cleaning time
Press the clock function button à twice. The remaining
cooking time without cooling down time is shown for a few
seconds.
Cancelling the setting
Switch off the appliance using the operating mode selector. If
the oven is already locked, you cannot open the oven door until
the “Door locked” display goes out.
Setting cleaning to run overnight
So that you can use your oven throughout the day, delay the
end of the cleaning process to during the night. See the section
Electronic clock, Setting a later end time .
After cleaning
Once the cooking compartment has cooled down, wipe out the
ash that has been left behind in the cooking compartment with
a damp cloth.
™‡
Set the mains voltage
‚ = 220-230V
ƒ = 230-240 V
Adjust the mains voltage
™ˆ ‚
= do not restore factory settings
ƒ
= restore factory settings
Reverse all changes and restore basic
settings.
Basic setting Options Explanation