26
5.
Lift the door handle slightly using both thumbs and lift out the
appliance door (Fig. G).
Fitting the appliance door
1.
Hold the appliance door and raise the door handle slightly
with both thumbs (Fig. A).
2.
Fit the appliance door in the left and right-hand guide rollers
simultaneously (Fig. B).
3.
Ensure that the appliance door does not tilt unevenly and that
it is properly fitted in place (Fig. C).
4.
Use a coin to release both locks on the appliance door
(Fig. D).
Left lock: anti-clockwise
Right lock: clockwise
5.
Open the appliance door a little wider and then close it.
ã=
Risk of injury from hinge locks which have not been
properly closed!
The appliance door may detach itself. You may be injured
and the appliance door damaged. After refitting the door,
always close the left and right-hand hinge locks.
6.
Close the left and right-hand hinge locks (Fig. E).
To do this, push the hinge lock (Fig. F) fully upwards on both
sides with a screwdriver.
Cleaning the door panels
To facilitate cleaning, you can remove the door panels from the
appliance door.
ã=
Risk of injury!
The components inside the appliance door may have sharp
edges. Take care not to cut yourself. Wear protective gloves.
ã=
Risk of injury!
The appliance must not be used again until the door panels
and appliance door have been correctly fitted.
Removing the door panel
1.
Unhook the appliance door and lay it on a soft, clean surface
with the front side facing downwards (see section: Removing
and installing the appliance door).
2.
Disengage and pull out the door panel from the latch on the
appliance door by lifting slightly.
Removing the intermediate panel
Before removing, make a note of the position in which the
intermediate panel is fitted, so that you do not refit it the wrong
way round later.
1.
Press the left and right holders in the direction of the arrow
(Fig. A) and disengage the intermediate panel.
2.
Raise and pull out the intermediate panel (Fig. B).
Cleaning
Clean the door panels with glass cleaner and a soft cloth.
Caution!
Do not use any sharp or abrasive medium or a glass scraper.
The glass could be damaged.
Fitting the intermediate panel
1.
Insert the intermediate panel into the three supports (Fig. A).
2.
Press on the intermediate panel on the left and right next to
the holders until it engages in the holders (Fig. B).
*
$
%
&
'
)
(
$
%
$
%
