Page 7 of 16
Installation
Neets Sound Bar - SB1 is designed to be easily installed, in any convenient location. It can be
hung on the wall beneath, or above a screen, or placed on a desk free standing.
To use the Sound Bar freestanding on a desk, simply unpack the unit mount the adhesive feet,
and it is ready to go.
To use the Sound Bar on a wall use the included brackets, screws and when necessary wall plugs.
Unpack the unit, make the measurements on the wall and place the unit on the surface where it
should be mounted.
Add the Velcro band to the rear of the PSU as well as in the connection tray, at the
rear of the Sound Bar, and place the PSU in the connection tray. As well as connecting
the power, it is also recommended to connect the audio cables, before mounting on
the wall.
Incluced in the box is a template for easy mounting. Use a level to ensure the template is
horizontally, and then tape the template securely to the wall. Use an awl or other sharp object to
punch 4 small holes through 4 of the marked locations on the template.
Remove the template from the wall and drill pilot holes. Pre-drilling is optional, however it will
result in a more accurate installation.
Insert and secure the wall anchors.
If drilling into wood stud, do not use the wall anchors.
If drilling into Sheetrock, screw the wall anchors into the drywall with a Phillips head screwdriver
until the head is flat against the wall surface. Be careful not to overtighten.
Fasten the Sound Bar brackets to the wall, using the screws supplied in the wall mount kit. Use a
level to verify accuracy a final time, and then tighten the screws securely.
Hang the Neets Sound Bar securely on the two (2) brackets.
For mounting the Sound Bar to a cart, use the VESA 400 or 800 holes at the rear of the Sound
Bar.
!
50 mm
750 mm
Center Line
50 mm
