Neets 312-0003, Manual

Page: 15 / 20

Doc. no: 312-0003-002-001 Rev 1.06 Page 14 of 19
Amplifier Communications protocol
Admin audio
Description Syntax Data Read/Write Default
Select input 1 – 4 NEAMP1,INPUT=<data> 1 – 4 (3 in 312-0001) R/W 1
Set volume NEAMP1,VOL=<data> 0 – 51 R/W 0
Set bass NEAMP1,BASS=<data> -7 – 7 R/W 0
Set treble NEAMP1,TREBLE=<data> -7 – 7 R/W 0
Set balance NEAMP1,BAL=<data> -79 – 79 R/W 0
Mute NEAMP1,MUTE=<data> ON , OFF R/W OFF
Power state (When the amp
are turned off it restores it
defaults values) NEAMP1,POWER=<data> ON , OFF R/W OFF
Input 1-4
Description Syntax Data Read/Write Default
Preset input 1 – 4, bass NEAMP1,INPUT:<input>,BASS=<data> -7 – 7 R/W 0
Preset input 1 – 4, treble NEAMP1,INPUT:<input>,TREBLE =<data> -7 – 7 R/W 0
Preset input 1 – 4, gain NEAMP1,INPUT:<input>,GAIN=<data> 0 – 15 R/W 0
Preset input 1 – 4, balance NEAMP1,INPUT:<input>,BAL=<data> -79 – 79 R/W 0
Microphone
Description Syntax Data Read/Write Default
Microphone gain NEAMP1,MICGAIN=<data> 0 – 63 R/W 25
Phantom power NEAMP1,PHANTOMPOWER=<data> ON, OFF R/W OFF
Admin
Description Syntax Data Read/Write Default
Set amp IP address NEAMP1,IPADDRESS=<data> xxx.xxx.xxx.xxx R/W 192.168.254.252
Set amp sub net NEAMP1,IPSUBNET=<data> xxx.xxx.xxx.xxx R/W 255.255.255.0
Set amp gateway NEAMP1,IPGATEWAY=<data> xxx.xxx.xxx.xxx R/W 192.168.254.1
Select if DHCP are used or not. NEAMP1,IPDHCP=<data> ON, OFF R/W OFF
Amp, SN NEAMP1,UNITSN=<data> 8 character R
Amp, Username for homepage NEAMP1,WWWUSER=<data> Max 8 character R/W Admin
Amp, Password for homepage. NEAMP1,WWWPSW=<data> Max 8 character R/W Admin
LAN speed (F = Full duplex,
H = Half duplex) NEAMP1,IPSPEED=<data> 10F, 10H, 100F,
100H R/W 100F
RS-232 Remote Control port settings
RS-232 port: 1
Baud rate: 9600
Data bits: 8
Stop bits: 1
Parity: None
Protocol: As bellow
Network LAN port settings
TCP port: 5000
Protocol: As bellow