VP1006-200PM-00 OEM ISO Reader
Manual version 2.6 / Page
7
5.5 Antenna tuning with EWA antenna transformer
In case a stainless steel loop antenna is used.
Jumper position in the EWA
Measure the circumference of the antenna-loop. Set jumpers to the combination as described in the
table on Antenna-Transformer PCB. Note that the highest possible number should be chosen.
EWA connection to the VP1006
9 : 1
11 : 1
13 : 1
15 : 1
Use connection 9 :1 to start
Tuning
Use a plastic screw driver to tune. Tune the coil inside the EWA until the green LED of the antenna
tuning is on. When green the antenna tuning is ok. See also instructions on previous page.
When it is not possible to get a green LED use another connection and try again.
5.6 Software setup
The software in the connected controller determines how the inputs and outputs on the VP1006 are
controlled. See manual with the relevant settings to configure the software for this VP1006.
When the software setup is done the VP1006 is ready for use.
