ANPR ACCESS | INSTALLATION GUIDE
Configuration
13/36
Single-point
Gain:
Indicates the gain of the vehicle signal.
Shutter us:
Indicates the exposure time in microseconds.
Strobe us:
Activation time of the infrared illuminator in
microseconds.
Multi-point
In this section it is possible to set the parameters for the multi-point grabbing mode.
This mode cyclically uses the work points Gain0/Shutter0, Gain1/Shutter1,
Gain2/Shutter2 and Gain3/Shutter3. Too light or too dark images are automatically
excluded from processing by the ANPR software.
Set values must be steady crescent. This means that Gain3 ≥ Gain2 ≥ Gain1 ≥ Gain0
and Shutter3 ≥ Shutter2 ≥ Shutter1 ≥ Shutter0. The web page does not allow setting
values that do not comply with these requirements.
Gain0:
Indicates the gain of the vehicle signal for work point 0.
Shutter0 us:
Indicates the exposure time in microseconds for work
point 0.
Gain1:
Indicates the gain of the vehicle signal for work point 1.
Shutter1 us:
Indicates the exposure time in microseconds for work
point 1.
Gain2:
Indicates the gain of the vehicle signal for work point 2.
Shutter2 us:
Indicates the exposure time in microseconds for work
point 2.
Gain3:
Indicates the gain of the vehicle signal for work point 3.
Shutter3 us:
Indicates the exposure time in microseconds for work
point 3.
Function buttons
Start Live:
Start live video displaying.
Stop Live:
Stop live video displaying.
Apply:
Confirm entered configuration values.
Reset:
Cancel entered configuration values that not have already
been confirmed with the Apply-button.
Note
Image processing engine is
stopped during live video
displaying!
