FITTING A NEW DOOR GLASS
REPLACEMENT SPARE PARTS LIST
ADJUSTING THE DOOR LATCH
This task may be easier with the door removed
from the appliance and laid horizontally. To
replace the door glass:
•
Two stainless steel strips hold the glass in
place. Remove the four M4 size Phillips
head screws from the stainless steel
strips.
•
Take out the glass, and check if the grey
rope beneath needs replacing. If so
replace this rope as well.
•
Position the new glass on top of the grey
rope and re-fit the stainless steel strips
and M4 screws.
•
Take extra care not to over-tighten the
screws, otherwise the glass will crack
when the heater gets hot and the door
expands.
•
On occasion, the M4 screws will have
deteriorated from the constant heat in
the firebox resulting in them snapping off
when trying to loosen them. In this case,
a new hole can be drilled in the door and
tapped using a 3.4mm drill bit, and M4
tap.
FIREBRICKS
21 x full bricks – 234(h) x 118(w) x 40(d)mm
4 x half bricks – 175(h) x 115(w) x 40(d)mm
BRICK RETAINER
655mm x 445mm
BAFFLE PLATES
Upper Baffle Plate:
400(w) x 160(d) in 5mm steel
Lower Baffle Plate:
500(w) x 300(d) in 12mm steel
ASH PLATE
500(w) x 75(h) x 50(d)mm in 5mm steel
GLASS SEAL
1360mm 8mm x 3mm
GLASS OF DOOR
476mm x 200mm x 5mm
DOOR ROPE
1580mm x 13mm round braided ceramic rope
•
If the door does not close firmly, then the
door latch can be adjusted.
•
In the front lower right-hand corner of
the door opening, inside the firebox, is a
welded tab which the door latch secures
against when the door is closed. Using a
large flat-end screw driver, place it under
the base of the tab and gently lever it out.
•
Close the door with the door handle
to test for any improvement. If no
improvement, repeat process until door
can be closed firmly.
MAINTENANCE and SERVICING
