4
1.5.
INSTALLING THE FLUE
Before installing flue, the bypass damper handle must be
fitted (see section ‘Installing the Bypass Damper Handle’).
The flue system used when installing the heater MUST comply
with the current installation standard AS/NZS 2918.
Full instructions on the installation of the flue will be supplied
with the flue kit. These MUST be adhered to, including the
minimum exit height from the top of the floor protector being
not less than 4.6m, and the minimum exit height above the
roof line of roof ridge as detailed in the instructions.
The flue must be fitted with a 900mm long, minimum 180°
arc, stainless steel rear flue shield.
If the draft is insufficient or periodic down drafting occurs and
the heater smokes or only burns slowly, extending the flue or
fitting a specialist cowl will usually resolve the issue.
If the stove is fitted to an existing chimney, ensure that it is
sealed at the base of the chimney with a register plate and fit
the flue pipe up through the plate and continue until it
terminates outside the chimney in accordance with AS2918
4.9.1.
1.6.
INSTALLING FIREBOX SIDE SHIELDS
The Nectre Bakers Oven is supplied with two 8 mm thick
sacrificial shields fitted to the sides of the firebox to protect
the walls of the firebox.
Lugs on the shields allow them to hang over the angled cutout
on the sides of the firebox along the top.
The firebox side shields may already be in place upon arrival
of the new appliance.
1.7.
WHERE A WATER JACKET IS FITTED
WARNING: DO NOT CONNECT TO AN UNVENTED HOT
WATER SYSTEM.
INSTALL IN ACCORDANCE WITH AS/NZS 3500.4 OR NZS 4603
AND THE APPROPRIATE REQUIREMENTS OF THE RELEVANT
BUILDING CODE OR CODES.
1.8.
TECHNICAL DATA
Specification
Bakers Oven
Minimum flue diameter
150mm/6 inches
Appliance size (WxDxH)
550x535x825mm
Oven size (WxDxH)
360x340x280mm (34 Litres)
Firebox size (WxDxH)
360x340x395mm
Flue spigot centre to rear of
appliance
140mm
Total mass of appliance
120kg
