
4-62, ISDN Extension-based Caller ID Assignment
DRAFT 3
Chapter 1 – 467
Xen IPK
Programming Manual
Doc. No
.: 8194 -
Rele
ase 2.
0
December
2004
System Mode
4
Submode
—
Data No.
62
PC Programming
+ BTT
ISDN Extension-based Caller
ID Assignment
General Description
This Memory Block provides the station DID Number (CPN, Calling Party Number) to the
Network when placing outgoing calls.
Display
Programming Procedures
1
Go off-line.
2
Press LK4 +
FB
to access the Memory Block.
3
Use the following to enter data:
J
to move the cursor left.
L
to move the cursor right.
K
~
I
to enter numeric data.
– OR –
Press
R
to go to the next TEL port number.
Press
U
to clear data.
Setting Data:
Telephone number to be programmed must
include area code, minus leading 0.
e.g.: 3 X X X X – X X X X
4
Press
N
to write the data and display Memory Block , 4-01.
5
Program Memory Block , 4-01 or press
P
to go back on-line.
Related Programming
M.B. Number
Memory Block Name
ISDN Trunk Directory Number Assignment
ISDN Directory Number Selection
N
1. A maximum of 13 digits is allowed.
2. Hyphens/dashes are not allowed when entering the directory number.
3. This Memory Block supports only trunks assigned as DID in Memory Block , 3-91.
4. When using CO Line Mode, Memory Block , 3-53 is used to assign the directory number of ISDN.
5. Only numbers within the indial range are valid.
0 1 / 6 2 :
T I M E
D I S P L A Y
Data
No.
Tel Port No.
(01~CO)
Setting
Data