NEC XEN IPK DIGITAL TELEPHONE, Programming Manual, Page: 423 / 638

3-91, Trunk Type Selection
DRAFT 3
Chapter 1 – 403
Xen IPK Programming Manual
Doc. No
.: 8194 -
Rele
ase 2.
0
December
2004
3-91
System Mode
3
Submode
—
Data No.
91
PC Programming
+ BCT
Trunk Type Selection
General Description
This Memory Block specifies each external line as CO line, PBX/CTX line, Tie/DID line, or CTX
Assume - 9.
Display
Settings
LK 1 LK 2 LK 3 LK 4
The shaded area indicates
the default setting.
CO PBX/CTX Tie DID
LK 5 LK 6 LK 7 LK 8
CTX Assume - 9
Programming Procedures
1
Go off-line.
2
Press LK3 +
N
+
IA
to access the Memory Block.
3
Press the corresponding CO/PBX line key to change the data option.
Note: Use the following to enter data:
J to move the cursor left
L
to move the cursor right
R
to go to the next CO/PBX Line No.
4 Press
N
to write the data.
5 Press
P
to go back on-line.
Related Programming
No related programming is necessary for this Memory Block.
N
1. Integrated Services Digital Network (ISDN) lines cannot be assigned as PBX/CTX or CTX Assume-9. A CTX Transfer
will not work on ISDN lines.
2. This Memory Block specifies if ISDN lines are to be DID or normal CO ring.
0 1 / 9 1 : C O
T I M E D I S P L A Y
Title
Data
No.
CO/PBX
No.
(01~64)