454 – Chapter 1
DRAFT 3
Caller ID Display for CAR Key, 4-49
December 2004
NEC Business Solutions Ltd
Doc.
No.: 8194 -
Release 2.0
Dece
mber 2004
System Mode
4
Submode
—
Data No.
49
PC Programming
+ AI
Caller ID Display for CAR Key
General Description
This Memory Block assigns one Multiline Terminal per CAR to display Caller ID Indication on
incoming CAR calls.
This memory block is not applicable to IPK R2000 and above.
Display
Programming Procedures
1
Go off-line.
2
Press LK1 + LK10 +
KF
to access the Memory Block.
3
Use the dial pad to enter Setting Data.
Note:
Use the following to enter data:
J
to move the cursor left
L
to move the cursor right
K
~
I
to enter numeric data
R
to select next CAR No.
Default Values
Not Specified
4
Press
N
to write the data.
5
Press
P
to go back on-line.
Related Programming
No related programming is necessary for this Memory Block.
N
To display Caller ID Indication for normal incoming CO calls and CAR incoming calls, both Caller ID Indication and Ring
assignment must be assigned for the terminal in System Programming. A maximum of 15 Multiline Terminals can be
assigned system-wide to display caller identification for normal incoming CO calls and CAR incoming calls using Memory
Block , 1-1-78 , Caller ID Display Assignment for System Mode. A sixteenth Multiline Terminal can be assigned to display
caller identification for CAR incoming calls per CAR using this Memory Block.
0 1 / 4 9 : C A L L
I D
0 0
T I M E
D I S P L A Y
Data
No.
Tel Port No.
(01~99)
A0~C0
Title
CAR Port
No.
