1-1-78, Caller ID Display Assignment for System Mode
DRAFT 3
Chapter 1 – 119
Xen IPK
Programming Manual
Doc. No
.: 8194 -
Rele
ase 2.
0
December
2004
1-1-78
System Mode
1
Submode
1
Data No.
78
PC Programming
+ AI
Caller ID Display Assignment
for System Mode
General Description
Use this Memory Block to assign up to 15 Multiline Terminals to display Caller ID Indication for
normal incoming CO/PBX calls or CO/PBX calls ringing a Call Arrival (CAR) key.
This memory block is removed with IPK R2000 and above.
Display
Programming Procedures
1
Go off-line.
2
Press LK1 + LK1 +
GH
to access the Memory Block.
3
Use the dial pad to enter Entry No.1 or 2 and Tel Port No.
Note:
Use the following to enter data:
J
to move the cursor left
L
to move the cursor right
K
~
I
to enter numeric data
Default Values
Not specified
4
Press
N
to write the data and advance to the next Entry No. After data for Entry No. 2 is entered, press
N
again. A
total of 15 entries can be made.
5
Press
P
to go back on-line.
Related Programming
No related programming is necessary for this Memory Block.
N
1. To display Caller ID Indication for normal incoming and CAR incoming calls, Caller ID Indication and Ring Assignment
must be assigned for the terminal in system programming.
2. Fifteen Multiline Terminals can be assigned system-wide to display Caller ID.
3. A sixteenth terminal can be assigned to display Caller ID using another Memory Block.
7 8 : C A L L I D
1
=
0 0
T I M E
D I S P L A Y
Data
No.
Title
1~7
Entry
No.
1~15
Tel Port No.
(00~99 A0~A9
B0~B9 CO)
