Data Assignment
Chapter 4
INITIAL SETUP
145
The following is an example when connecting WL1700-MS to LAN/WAN.
Connect the LAN cable to Ether connector of WL1700-MS.
22
Check to see if the Controller is operating normally in your network.
Check the Controller by using
ping
or
tracert
command.
Besides, use
telnet
command to log in to the Controller and use
show
command to check the parameters assigned. For more information on those
commands, refer to
“Check Configurations/Network Status” on page 106
l
When using WL1700-MS
After confirming that the Controller is in normal state, attach the WL
Intelligence Access Point to an appropriate location. For more information,
refer to
“Access Point Installation” on page 58
10BASE-T/100BASE-TX
PoE HUB
.#09#0
PoE Feeding Adaptor/
PoE HUB
Connect a LAN cable to the Ether Connector.
Rear
Setup PC
Basic Settings
Summary of Contents for WL1700-MS
